Re: Conferencing Problems Exchange 2000

From: "Nuevo" <imaneophyte@xxxxxxxxx>
Date: Fri, 3 Feb 2006 10:40:28 -0500

Wrong forum to post but check your routers for broadcast and multicast
support. This is probably a factor.

Nue
"cyb165er" <cyb165er@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:761B2021-1AFD-4B68-8B50-AA44CF6FA8E6@xxxxxxxxxxxxxxxx

Hi,
I use exchange 2000 options to videconference in me network.
We have many subnets.
All the optios run fine in one subnet (webcam, audio, chat, sharing
application...) but in diferents subnets (behind routers) no show the
webcam.
In the routers i permit all ip protocols.
The videoconfenece use any protocol that routers no route?

Or nay other tips?

Thanks in advanced

Prev by Date: Re: 5.5 to 2003 Move mailbox problem.
Next by Date: Re: Resolving Sender Display Name
Previous by thread: Re: What is the best way to block incoming email from a specific domai
Next by thread: Forwarding messages based on age
Index(es):
- Date
- Thread

Relevant Pages

Re: Best solution to segment subnets
... i have a no clear idea of this scenario, maybe so nat routers are confusing me. ... subnet 1 and subnet 2 are two room in the second floor, i need isolate them from subnet 3 and from each other. ... Three subnets need internet. ... It won't isolate the subnets if the switches are uplinked to each other. ...
(microsoft.public.win2000.ras_routing)
Re: Best approach for broadcasting a notifivation to another progr
... I think that normally routers block all broadcasts by default, ... I have found that many admins will allow broadcasts between them (at least ... As for the Terminal server issue, I don't know how that would do. ... I have a customer that has two subnets joined by Cisco pix ...
(microsoft.public.vb.general.discussion)
Re: EIGRP Configuration Help
... all single-homed locations are configured as stub. ... Subnets again much similar. ... The network design is archaic and a relic of the past in terms of subnets, ... stub routing on each of these routers. ...
(comp.dcom.sys.cisco)
Re: Network Configuration
... You have the physical topology, the logical topology, and ... cross routers, therefore the routers will recover lost bandwith. ... > We currently have three router/hub/switches one, for each floor of our> building. ... I am contemplating going to DHCP and am> interested in knowing if there is a technical reason, why I should try to> keep the subnets focused on each floor. ...
(microsoft.public.win2000.networking)
Help: Tunneling multicast
... I want to tunnel multicast DNS (zeroconf/rendezvous, ... The routers connecting ... these subnets do not route multicast, and I don't control the router. ... But I do have linux boxes in all four subnets. ...
(comp.os.linux.networking)