exchange 5.5 delivery timeout

From: MH (m_at_m.com)
Date: 02/27/05 

Date: Sun, 27 Feb 2005 16:32:52 +1100

Hi,

I've seemed to look everywhere for the flag to increase the SMTP delivery
timeout but I cant find it in the admin console. I read in an article where
I might have to go into the registry and change this flag would anyone know
where? Or am I missing something in admin console?

Error in Outlook says something like " Message could not be sent, Exceeded
maximum delivery timeout."

Thanks

Relevant Pages

  • Re: Not reading, or sending, fast enough on my serial application
    ... on the descriptor and then use selectwith a timeout of 30 seconds on ... VMIN to 255 AND I'm setting the flags to FNDELAY, ... use the FNDELAY open flag and set VMIN to 255??? ...
    (comp.unix.programmer)
  • Re: Peeking in to the serial buffer
    ... > think) flag, and provide a timeout value as one of the parameters. ... Setup up the serial port and flush the buffer to remove any ... Have a QIO (not QIOW) that completes when there are two bytes in the ...
    (comp.os.vms)
  • Re: Best way to share data between threads
    ... > instrument that needs firmware ftp'ed to it after a cold start, ... I usually get around this by polling on a thread flag until its ... state changes as expected or a timeout occurs. ...
    (freebsd-questions)
  • Re: A better interface, perhaps: a timed signal flag
    ... the kernel would setup a flag for you and then map it into userspace. ... and limiting this facility to one such timeout per ...
    (Linux-Kernel)
Loading