Reading and Writing From USB and RS-232

From: JRB (JRB_at_discussions.microsoft.com)
Date: 09/12/04 

Date: Sun, 12 Sep 2004 16:45:02 -0700

I need to read from and write to USB and RS-232 ports in a new project I'm
working on. I was thinking about using C#, but I'm not sure if there's a way
to do this in that language. If not, any suggestions on what to use? (ie.
Visual C++, Visual Basic, etc). Thanks for any feedback.

Relevant Pages

  • Re: AHCI - remove probing of ata2
    ... ACPI: bus type pci registered ... registered new interface driver hub ... USB Universal Host Controller Interface driver v3.0 ... hub 1-0:1.0: 2 ports detected ...
    (Linux-Kernel)
  • Re: Help interpreting AHCI failure messages
    ... investigate I decided to try putting the root fs on a usb memory stick ... PERCPU: Allocating 57344 bytes of per cpu data ... registered new interface driver hub ... hub 1-0:1.0: 6 ports detected ...
    (Linux-Kernel)
  • Usb problems on 7.0 RELEASE
    ... Earlier I reported usb problems on this list. ... 686-class CPU) ... <Enhanced SpeedStep Frequency Control> on cpu0 ... 2 ports with 2 removable, ...
    (freebsd-stable)
  • Re: Frequent USB mouse disconnections under load with RELENG_7]
    ... disconnections of the mice. ... A mouse attached via a second pair of USB ports, ...
    (freebsd-stable)
  • OOPS in 2.6.19.1, connected to nfs4 and autofs4
    ... ACPI: Local APIC address 0xfee00000 ... Linux Plug and Play Support v0.97 Adam Belay ... USB Universal Host Controller Interface driver v3.0 ... hub 1-0:1.0: 2 ports detected ...
    (Linux-Kernel)