Re: Help in accessing GPIOs in an i.MX21 (ADS21 board)

What GPIO method calls?

Paul T.

"Mario" <alphatommy@xxxxxxxxxxx> wrote in message
news:1158076582.805617.137440@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Hi,

Has anyone had any success in accessing (reading and writing) the GPIOs
in a Freescale i.MX21 (ADS21 board) from a managed code application?
The problem that I have is that regardless of which port parameter I
pass in the GPIO method calls, the GPIO driver always take Port_A as
default. The rest of the parameters are passed correctly. Any inputs
or suggestions on how to fix this is appreciated. Thanks.

I am not sure if this is the correct forum, but I did not get any
response after posting the same question in the freescale site for
almost two weeks.


-- mario



.