Re: Problem with USB High Speed Hub

Show the customer that the problem happens also with other devices. For
example, plug in a flash device and start file copy to/from it. Unplug
another device on this hub and see what happens.

"Sushma" <sushma.yella@xxxxxxxxx> wrote in message
news:e3fd6936-ba79-467c-9c1d-93bde8d608a2@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Thank You.
We had already tried with couple of other hubs from Cypress(same
model) but still the same issue. If we had used a hub other than from
Cypress it is working fine.

Any other suggestions?

Regards,
Sushma


.

Relevant Pages

  • Re: USB mouse not detected on boot of 7-STABLE
    ... being detected at boot time. ... The /dev/ums0 device simply does not appear unless I unplug the mouse ... and plug it back in again. ... When connected to a hub, ...
    (freebsd-stable)
  • Re: USB Hub issue
    ... There is no software for the hub. ... Strictly plug and play. ... >> works when I unplug the hub from the laptop then plug it back in or if I ...
    (microsoft.public.windowsxp.general)
  • Re: cast iron cleanout adapter
    ... This 4" SV CI hub serves as the cleanout from that point downstream. ... There has always been a 4" test plug in that hub. ... The brass plug you found is probably for a pressure line. ...
    (alt.home.repair)
  • Re: Rant: A Nasty Bit of Windows in Snow Leopard
    ... Since I installed Snow Leopard, each time I plug in my USB ... I get the prompt _every_ time I plug in the USB hub to which the serial ...
    (comp.sys.mac.system)
  • Re: Grounding 101
    ... I don't think that I would ground the hub. ... It uses a polarized plug. ... > The computers on this hub are properly grounded with 3 prong plugs. ... > active BNC plug. ...
    (comp.sys.ibm.ps2.hardware)
Loading