dbgprint doesn't list variables



Hi all,

We have dbgprints in our driver, but it only outputs text messages,
variables are always empty, although we are sure, in reality they are not.

Any suggestions?
Thanks.

Beat and Mike


.



Relevant Pages

  • Re: Server 500 Locked Bios
    ... I had this problem, many years ago, and managed to crack it. ... There isn't a W95/98 driver for this RAID card, ... Booted Server 500 on W98SE boot disk and read C:\config.sys ... Slot 2 Empty ...
    (comp.sys.ibm.ps2.hardware)
  • Re: FA: Synaco ST-70 Tube Amplifier/Upgraded
    ... I prefer my speakers to be as colorless as possible, ... understand the actual claims vs. reality of any item before one invests ... if measured 'colorlessness' is your aim, built a Volt RV4504 driver based ... That poor little cone will have to ...
    (rec.audio.tubes)
  • Adding IP Ports and Printers to a Print Server
    ... The script adds the appropriate port and printer and seems to work ... ' configures some driver and port information. ... required and cannot be empty. ... 'The following code specifies the printer driver to use. ...
    (microsoft.public.scripting.vbscript)
  • Re: BBC Radio 2 Jeremy Vine show.
    ... Apart from us, the road was empty, so if he'd waited about 3 seconds, he ... I see idiotic and dangerous car driving every day of ... In the situation you describe above, it might just be that the truck driver ... speed limit. ...
    (uk.rec.driving)
  • Re: Who causes congestion again?
    ... Conveniently misses out the fact that bus lanes are often empty, ... driver, an MPV can normally carry 6 passengers as well as the driver. ... The ideal solution is pooling. ...
    (uk.rec.cycling)

Loading