I'm trying to avoid the problem of needing to remain connected to the
server while the command is running. I have had some connectivity
problems with my server and am trying to run several procedures, some
of which run for a few hours.
Re: Cannot get FTP to Work - disconnects ...Connection closed by remote host ... This is an immediate action by the server,...IIS ftp config is simple, just that the network part is really mess up. ... When I connect from a different server I can run any FTP command.... (microsoft.public.inetserver.iis.ftp)
Re: New to VPN... ... I have already mapped the drive to a folder on the server with the command...VPN connection doesn't work, ... you have to word them like a server administrator would, ... (microsoft.public.windows.server.general)
Re: New to VPN... ... I have already mapped the drive to a folder on the server with the command...VPN connection doesn't work, ... (microsoft.public.windows.server.general)
Re: Is this possible? ... running on the server, and is the driver being used too. ... same error: Command contains unrecognized phrase/keyword. ... closes a single table in the specified work area.... FoxPro command to close the table before I close the connection?... (microsoft.public.fox.programmer.exchange)
RE: Your message did not reach some or all of the intended recipie ... In your details you are saying to type the following command... > SMTP telnet session.... When the issue happens again, in the Exchange Server, please telnet ... > times to close the connection to the server and leave the Telnet session ... (microsoft.public.windows.server.sbs)
